Installation Video
HOW TO INSTALL?
STEP ONE
The first step is to contour your snap shades to the curve of the car door. Since the frame is made of bendable wire, it can be slightly bent to provide a tighter fit to your car door.
STEP TWO
Attach the metal mounts to the magnets and match the snap shades on the window. Mark the points of contact for the corresponding installation of the fixtures. The angle of the metal fastening is normally 90 degrees and they can be adjusted to suit the magnets on your snap shades.
STEP THREE
Degrease the surface, then lightly warm up the double-sided 3M tape.
Remove the red protective film and attach the metal mounts to the intended locations on the window frame press down for 1-2 minutes.
STEP FOUR
If you do it not do it for the first time,
do not worry! Try again using an
extra tape that is available in your kit. Attach the Screen to the installed mountings.